toyota gps navigation oemcargps benz gps navigation oemcargps bmw gps navigation oemcargps audi gps navigation oemcargps

OemCarGPS:

How to Remove Nissan sentra stereo radio 1997-2000

Posted by Rongzhenquan under Car GPS installation DIY, Nissan

6 steps to show you How to Remove Nissan sentra stereo radio 1997-2000 by yourself step by step. Have fun here!


Step 1:
With a small flat head screwdriver or a small sharp pointed tool unsnap the plastic cover located between the hazard switch and the defrost switch.
Behind the cover will be one Phillips screw. Remove the screw.

Step 2:
With the same small flat head screwdriver or sharp pointed tool, insert the tip between on of the top corners of the main dash. Gently pry the plastic panel until you can reach your fingers behind the plastic dash panel. Pull the top of the plastic dash panel until it unsnaps from the body of the main dash.

Step 3:
pull the bottom of the plastic dash panel until it unsnaps from the body of the main dash.

Step 4:
Once the plastic dash panel has been completely unsnapped from the dash, you will notice connectors attached to the rear of both the hazard switch and defrost switch. Unplug both connectors and the plastic dash panel can be completely removed from the body of the main dash.

Step 5:
Once the plastic dash panel has been pulled off, the screws securing each side of the radio should be visible. Locate and remove four Phillips screws, (2) screws on each side of the (4) screws, the radio will pull out with the pocket attached.

Step 6:
Unplug the antenna cable from the rear of the radio. Unplug 2 white connectors plugged into the rear of the radio. Pull the radio/pocket assembly completely from the dash.
 

You May Also Like

Views: 1,762
Not Rated
Score: n/a
Rating: n/a
1 Star2 Stars3 Stars4 Stars5 Stars6 Stars7 Stars8 Stars9 Stars
Loading ... Loading ...

Leave a Reply


*